This is exactly my experience as well.

Magnets have no effect on flash memory or storage.

Based lyrics. YouTube can auto-translate.

Looks more like a photoshop to me.

Agreed, I didn’t recognize him at first.

I think that is Ashton Kutcher. He’s in the cast list for the show.

Replicated in Safari on iOS.

Replicated in Safari on iOS.

Not quite accurate. The indentation is there for a few reasons. Source: https://www.sciencing.com/1865028/milk-jugs-dimple-reason/

I use Upsnap on a low-power SBC behind a reverse proxy: https://github.com/seriousm4x/UpSnap

Before that I used the WoL feature on my Asus router.

Openshot or Shotcut as well.

Unfortunately Dell pulls some shit with their PCs. Their boards are usually almost standard as @catloaf points out. I had a Dell Optiplex 990 that had a board advertised at ATX… but a few of the mount points were a few centimeters off. I thought I might be able to make do without a few mounting screws until I realized the cooler was actually designed to hold the board in place and would not be transferrable. I thought about getting a new cooler but the board was designed so the CPU was too near the edge of the case to fit most standard coolers. Not sure if they do this on purpose to make their parts ecosystem essentially closed or if there is some cost benefit reason but it blows either way.

I love that dock. I had four HDDs in two of these docks connected to one of my servers for a bit. Same experience. A bit slow for large transfers but fast enough for HD streaming. I think the space between the drives allows for enough natural airflow to keep them relatively cool. I think the hottest they got was 63 degrees Celsius during a large transfers. Usually stayed a bit below 60. In my janky homebrew NAS I see temperatures around 50, give or take 5 degrees. The use case should really determine the build so that may be the best option for many, especially with budget constraints.

The power supply probably won’t spin those drives and you may have some difficulty with thermal management. I used a SFF PC case with a SATA extender running outside to a few HDDs for a while. The drives got really hot until I got a fan running over them. This was a super janky setup though. Made a lot of dust. If you’re looking to stay low budget and don’t need RAID or SMART reporting then I would get an enclosure for those drives and just use USB. Otherwise see what you can Frankenstein from what you have. I built a NAS using my janky setup’s HDDs, CPU, and RAM. Got a cheap full size tower, old motherboard off eBay, basic cooler, and power supply for much cheaper than a new build. Still janky but upgradable with a lot of internal space for storage/GPUs.

What form factor is the m710q? I have a tiny FF so I’m imagining you trying to squeeze two HDDs into that… I was in a similar situation a while ago and broke down and bought a new case and transplanted my CPU and RAM. The options are only limited by your budget and needs when building

Thank you!

Got a recipe to share with us?

This right here. Since you can’t really configure the ISP router (1), DMZ is the way to go. The DMZ feature on home routers usually allows you to select a specific device or devices to add to the DMZ so make sure to reserve/set a static IP on your router (2) and configure the DMZ on your ISP router (1) to include only that specific IP. DMZ essentially forwards all ports to that device.

Sorry, I wasn’t trying to correct anyone, I had to look this up and that’s what my translator returned. I’m agreeing that this should be the de facto slogan for the White House (and most of Congress).

Stultitia et imperitivae = stupidity and ignorance. Couldn’t agree more with the spirit of this post.